Troubleshooting
Use the following information to solve common problems.
The LED does not blink when a button is pressed.
■
Replace the batteries. See "Inserting batteries" on page 6.
The LED blinks when a component mode is pressed, but the
component does not respond.
■
Make sure that you are less than 15 feet (4.57 meters) from the infrared
remote sensors on the component.
■
Make sure that nothing is blocking the infrared remote sensors on the
remote control or the component.
■
Make sure that the remote is programmed for that component. See
"Programming the remote control" on page 7.
The remote control will not accept the component program code.
■
Make sure that you followed all the steps in the programming procedure.
See "Programming the remote control" on page 7.
■
Make sure that you tried all the program codes listed for the component
manufacturer. See "Component program codes" on page 8.
■
Search for the component code. See "Searching for component codes" on
page 19.
www.gateway.com
Troubleshooting
33