Toro MMX-658K-P Operator's Manual page 37

8. Remove the bolt and nut that secure the rear
bracket for the engine deck hinge to the frame
of the machine (Figure
Figure 51
1. Engine deck
2. Pivot
3. Rear hinge bracket
9. Lift up the rear edge of the engine deck and
remove the hinge bracket
10. Slide the engine deck rearward and out from the
forward hinge bracket
Note:
Do not remove the forward hinge bracket.
Figure 52
11. Remove the engine and engine deck from the
machine (Figure
51).
4. Frame
5. Nut
6. Bolt
(Figure 51).
(Figure 52).
52).
Installing the Engine
1. Align the engine and engine deck to the rear
frame of the machine.
Note:
The drive pulley on the engine must align
forward.
2. Align the pivot on the engine deck with the
forward hinge bracket
3. Slide the engine deck forward and the pivot into
the forward hinge bracket
4. Align the rear hinge bracket with the pivot on the
engine-deck hinge
5. Lift up on the rear edge of the engine deck and
slip the hinge bracket onto the pivot.
6. Secure the rear bracket to the frame of the
machine using the bolt and nut
removed in step
(page 36).
7. Using a spring-removal tool (Toro Part No.
92-5771), install the tension spring to the anchor
g020120
bracket on the engine deck
8. Install the belts and belt guide; refer to
the Belts (page
9. Adjust the belt guide; refer to
Guide (page
10. Install the divider plate; refer to
Divider Plate (page
g020121
37
(Figure 52).
(Figure 52).
(Figure 52).
(Figure
8 of Removing the Engine
(Figure
44).
Adjusting the Belt
45).
Installing the
29).
51)
50).
Installing