Table of Contents
Advertisement
the engine is running, move the choke lever to the
O
position. Do not use the choke if the engine is
PEN
already warmed up or if the air temperature is high.
Throttle Lever
The throttle lever
(Figure 12
the speed (rpm) of the engine. It is located next to the
choke lever. It sets the engine speed and therefore
can increase and decrease the rotation speed of the
mixing paddles. For best performance, set this control
to the F
position when mixing material.
AST
Engine On/Off Switch
The On/Off switch is located on the front of the engine.
•
Rotate it to the O
N
engine.
•
Rotate it to the O
FF
1. O
position
FF
Recoil-Start Handle
To start the engine, pull the recoil-start handle
10
and
Figure
11) quickly to turn the engine over.
The engine controls described above must all be set
correctly for the engine to start.
Oil-Level Switch
The oil-level switch is located inside the engine, and it
does not allow the engine to run in the event the oil
level is below the safe operating limit.
and
Figure
11) controls
position to start and run the
position to shut off the engine.
Figure 14
2. O
position
N
g021103
(Figure
16
Advertisement
Table of Contents
