Accessories - Husqvarna 120e MARK II Operator's Manual

Equivalent vibration levels, a
2
Front handle, m/s
2
Rear handle, m/s
Saw chain/guide bar
Type of drive sprock-
et/number of teeth
Saw chain speed at
133% of maximum
engine power speed,
m/s.
Recommended cutting equipment
Chainsaw models Husqvarna 545 Mark II, 545G Mark II,
550 XP Mark II, 550 XPG Mark II have been evaluated
for safety according to EN ISO 11681-1:2011
(Machinery for forestry - Portable chainsaw safety
requirements and testing) and fulfill the safety
requirements when equipped with the below listed guide
bar and saw chain combinations.
Low kickback saw chain
A saw chain that is designated as Low kickback saw
chain, meets the low kickback requirement specified in
ANSI B175.1-2012.
Approved cutting equipment - 545 Mark II and 545G Mark II
Guide bar
Length, in/cm Pitch, in
13/33 0.325
15/38
16/41
18/46
20/50
4
Equivalent vibration level, according to ISO 22867, is calculated as the time-weighted energy total for vibration
levels under various working conditions. Reported data for equivalent vibration level has a typical statistical
dispersion (standard deviation) of 1 m/s
34
Husqvarna 545 Mark
II
4
hveq
3.6
4.1
Rim/7
25.4
Gauge, in/mm
0.050/1,3
2
.
Husqvarna 545G
Mark II
3.6
4.1
Rim/7
25.4

Accessories

Kickback and guide bar nose radius
For sprocket nose bars the nose radius is specified by
the number of teeth, such as 10T. For solid guide bars
the nose radius is specified by the dimension of the
nose radius. For a given guide bar length, you can use a
guide bar with smaller nose radius than given.
Note: The usable cutting length is usually 1 in less than
the nominal guide bar length.
Saw chain
Max. nose ra- Type
dius
11T Husqvarna
SP33G
Husqvarna 550 XP
Mark II
3.3
4.9
Rim/7
26.1
Length, drive
links (no.)
56
64
66
72
80
544 - 005 - 10.05.2019
Husqvarna 550 XPG
Mark II
3.3
4.9
Rim/7
26.1
Low kickback
Yes