Table of Contents
Advertisement
WARNING
Avoid Tip Over Hazard!
Do not use the dishwasher until it is completely
installed. When opening the door on an uninstalled
dishwasher, carefully open the door while
supporting the rear of the unit. Failure to follow
this warning can result in serious injury.
LEVELING THE DISHWASHER
The unit should now be ready to slide into the cabinet
opening. To avoid scratching the floor, use floor protection and
caution when sliding the dishwasher into the cabinet. Make
sure that the hoses and cords do not bunch up behind the
unit or kink as you slide the unit back. Make certain to slide
the unit into place before raising the leg levelers.
Level the dishwasher horizontally by turning feet clockwise
to raise or counter-clockwise to lower front of the unit.
Level the dishwasher vertically by turning center screw to
raise or lower the back.
Figure 19
SECURING THE DISHWASHER
Center the dishwasher in the opening before securing it to
your cabinet or countertop as shown in Figure 20. Use the
supplied emergency release tools (R) to open the appliance
as shown in Figure 21. Remove the top cutlery rack as
shown in Figure 22.
Figure 20
12
Figure 21
R
R
Figure 22
Drive the mounting screws through the holes in the mounting
brackets as shown for Top Mount (Figure 23), Side Mount
(Figure 24), and Alternative Side Mount (Figure 25).
For Top Mount - Wooden Countertop
D
For Side Mount - Stone Countertop
D
For Alternate Side Mount
N
When installing a heavy wooden door panel, adjust as shown
in Figure 26.
min. 70 mm
max. 150 mm
>150 mm
Figure 23
Figure 24
Figure 25
Figure 26
adjust
S
/
(2 mm)
1
16
~
/
" (12mm)
1
2
12
Advertisement
Table of Contents
