Table of Contents
Advertisement
Energy-Saving Cooling Mode (Optional)
Energy-saving cooling mode can save energy in cooling , because it
body-adaptation time according to the change of time and temperature and adjusting automatically desired
temperature.
E/SAVING
Forced operation
Operation procedures when the remote control can't be used.
The operation will be started if the ON/OFF button is pressed.
If you want to stop operation, re-press the button.
Cooling Model
Operating mode
Cooling
Indoor FAN Speed
Setting Temperature
Test operation
During the TEST OPERATION, the unit operates in cooling mode at high speed fan, regardless of room
temperature and resets in 18 minutes.
During test operation, if remote controller signal is received, the unit operates as remote controller sets.
If you want to use this operation, Press and hold the ON/OFF button for 3~5 seconds, then the buzzer sound
1 "beep".
If you want to stop the operation, re-press the button.
Display Luminosity (Optional)
The Display Luminosity can be open/close by using the remote control.
Press the start/stop button to start the unit. press LCD LUMINOSITY BUTTON
for open/close
1. Press the START/STOP BUTTON to start the unit.
2. Open the door on the remote controller.
Select cooling operation.
3. Press the ENERGY-SAVING COOLING MODE BUTTON.
4. To cancel the energy-saving cooling mode, press the ENERGY-SAVING
COOLING MODEL BUTTON again and unit will operate in previous
mode(Cooling or healty dehumidification mode).
Room Temp. ≥ 24°C
Cooling
High
High
22°C
22°C
can operate efficiently by setting
Heat pump Model
21°C ≤ Room Temp. < 24°C
Healthy Dehumidification
High
23°C
Operating Instructions
ON/OFF
button
Room Temp. < 21°C
Heating
High
24°C
LIGHT
Owner's Manual
13
Advertisement
Table of Contents
