Connecting The Supply Hose - LG SIGNATURE FH8G5XDNK3 Owner's Manual

Connecting the Supply Hose

• Water supply pressure must be between 0.1
MPa and 0.8 MPa (1.0‒8.0 kgf/cm
• Do not overtighten the water supply hose.
• If the water supply pressure is more than 0.8
MPa, a decompression device should be
installed.
• Periodically check the condition of the hose
and replace the hose if necessary.
• Contact the service centre if there is no rubber
seal.
Checking the Rubber Seal on the
Supply Hose
Two rubber seals are supplied with the water
supply hoses. They are used for preventing
water leaks. Make sure the connection to taps
is sufficiently tight.
Hose connector
Hose connector
).
2
Rubber seal
Rubber seal
Connecting Hose to Water Tap
Connecting Screw-Type Hose to Tap
with Thread
Screw the hose connector onto the water
supply tap.
Connecting Screw-Type Hose to Tap
Without Thread
1
Loose the four fixing screws.
Upper
connector
Fixing screw
2
Remove the guide plate if the tap is too
large to fit the adapter.
Guide plate
EN
Rubber
seal
15