Operation; Selecting An Input Source - Denon Professional DN-7000AVP User Manual

Operation

Selecting an Input Source

To select from the input source options, turn the Source Select knob on the front panel or press one of the
Quick Select buttons. Alternatively, press one of the pre-mapped source buttons on the remote control.
Saving Sources to Quick Select Buttons
1. Use the Source Select knob to select an input source.
2. Press and hold one of the Quick Select buttons for 2 seconds. The selected source will be stored to the
Quick Select location.
Adjusting Individual Surround Channel Volume
Press the Channel Select button on the remote control to cycle through each of the surround sound channels.
Use the  or  buttons to adjust the individual channel volume.
Adjusting the Master Volume
Adjust the Master Volume using the front panel knob. Alternatively, use the remote control  or  buttons to
adjust the master volume. Press the Mute button on the remote control to turn off the sound temporarily. To
cancel muting, press the Mute button again, adjust the Master Volume knob, or adjust the remote control Vol
+/- buttons.
Assigning Sources to the Input Connectors
This screen appears when the Input Setup ► Each Input Source ► Input Assign menu is selected. Use the
Input Assign menu to route the HDMI inputs, digital inputs, and component inputs to the different sources.
1. If DN-700AVP is powered off, press the Power button to power it on.
2. Press the Menu button on the remote control. Use the , ,◄, ► buttons to navigate to the Input Setup ►
Each Input Source ► Input Assign menu.
3. Use the , ,◄, ► buttons to move to the source you want to set.
4. Press Enter, then use cursor ◄ and ► buttons to select the input to be assigned.
5. Press Enter to save the setting.
Notes:
•
The default HDMI connector assignments/source numbers can be seen on the rear panel. These HDMI
connectors can be reassigned to different input sources. For example, the Blu-ray source which is assigned
to (5) BD by default can be reassigned to input (2) Game 2 from the Input Assign menu.
•
An input source to which an HDMI input connector cannot be assigned will be seen as – – –.
•
To play the video signal assigned at HDMI combined with the audio signal assigned at Input Assign ►
Digital, select Digital in the Input Mode.
•
When HDMI Control is set to On, the HDMI input cannot be assigned to TV.
Using the Dock Audio Inputs for Media Playback
1. If DN-700AVP is powered off, press the Power button to power it on.
2. Connect your media device to the Dock inputs on DN-700AVP.
3. Press Dock on the remote control or use the Source Select knob to choose Dock as the audio input source.
4. Start playback from your media device and adjust the source volume.
8