Ce Conformity; Rfi Suppression; Notes On Mounting The Rack - Cisco C800 Series Service Supplement Manual

3.3. CE Conformity

The device complies with the requirements of EC directives 2004/108/EEC regarding
"Electromagnetic Compatibility" and 2006/95/EEC "Low-Voltage Directive". This is indicated
by the CE certificate label (CE = Communauté Européenne) on the back of the device.

3.4. RFI Suppression

All other equipment which is connected to this product must also have radio noise suppression in
accordance with EC directive 89/336/EEC.
Products which meet this requirement are accompanied by a certificate to that effect issued by the
manufacturer and/or bear the CE mark. Products which do not meet this requirement may be operated
only with the special permission of the German Federal Approvals Office for Telecommunications (BZT).
This is "Class A" equipment. This equipment may cause harmful inter- ference in residential areas.
In this case, the user may be required to take appropriate measures and bear the costs resulting
from these measures.

3.5. Notes on Mounting the Rack

● For safety reasons, at least two people are required to install the storage subsystem because of its
weight and size.
● When connecting and disconnecting the cables, observe the notes in the operating manual for
your system and the chapter "Important notes" in the technical manual for the relevant rack.
● Ensure that the anti-tilt bracket is correctly mounted when you set up the rack.
● For safety reasons, no more than one unit may be pulled out of the rack at any one time during
installation and maintenance work.
● If more than one unit is pulled out at any one time, the rack may tip over.
● The rack must be connected to the mains by an authorized specialist (electrician).
10 Operating Manual
3.3CE Conformity