Table of Contents
Advertisement
Vars
WebPass
(String)
3.10 Miscellaneous Commands
These additional commands consist of those which are not commonly used, not considered to be a core part of
the MASCOT protocol, and support is most likely to vary between system types and firmware versions.
Command
Arguments
B
(0 | 1)
C
LockStatus
ReclkDis
[0 | 1]
RemoteSync
[0 | 1]
3.11 Command Reference
This section documents each MASCOT command in detail. Please note that command availability may vary
between firmware series and versions. Details of availability are documented for each command.
3.11.1 B Command
Carina series only
The B command is used for rebooting the system into Bootloader for software updates. See the
Updates
section for details.
3.11.2 C Command
Routers and MSC-GCP2U32 only
NOTE: Superseded by the
The C command queries the matrix size. The response is in the format "Dests,Srcs,Levels,Flags1,Flags2".
Where "Dests" is the count of system destinations, "Srcs" is the count of sources and "Levels" is the number of
system levels. The Flags1 and Flags2 fields are currently unused and will be 0.
Example for a 16x16 system with 2 levels
>C
16,16,2,0,0
>
3.11.3 DestNames Command
Routers and MSC-GCP2U32 only
Page 26 of 60
MSC-2HD2408S Product Manual
Query all system configuration variables.
Assign web password.
Description
Reboot system into Bootloader, typically used for software update. A 0 or 1
value is required and selects the Bootloader IP address. A value of 0 uses
192.168.2.59 and 1 uses configured system IP.
Query system matrix info, which is displayed in the format
DESTS,SRCS,LEVELS,FLAGS1,FLAGS2.
Superseded by the MtxCfg command.
Get video lock status and rate detection information (not all HD router
systems are supported).
Disable SDI reclockers (not all SDI router systems are supported).
Query or assign remote router syncing. Useful for creating a 3D system out
of 2 routers.
MtxCfg
Command.
© 2013-2018 Matrix Switch Corporation
Software
www.matrixswitch corp.com
Advertisement
Table of Contents
