Advertisement
CONNECTING THE SPEAKERS
FEATURES AND CONTROLS
LINE INPUT
LEVEL
SUB-SONIC
LPF
BASS BOOST
L
6V
0.2V
15Hz
45Hz
50Hz
250Hz
0dB
REMOTE
R
BASS
CONTROL
LINKABLE
POWER
PHASE SHIFT
MASTER
PROT.
SLAVE
12dB
0
180
MASTER
SLAVE
FEATURES AND CONTROLS
RCA Low Level Input Jacks
lt allows left and right inputs to be connected to the amplifier using RCA plugs.
RCA Line Output Jacks
Full range output from channel L&R inputs is provided at Line Out Jacks.
Input Level Control
It allows for the adjustment of the gain of both channels to match the output level
of the source. In addition, it allows for detailed adjustment with L&R level control
to be separated.
Subsonic Filter
It admits of removing the frequency below 15Hz to 45Hz using the Subsonic
Variable Control in order to protect subwoofer speaker or to produce
powerful subwoofer sound.
Bass Boost
Adjust the sub boost level of the selected frequency output from 0dB to 12dB.
Variable Highpass controls
Adjust the crossover frequency of the-High Pass output only, from 30Hz to 500Hz
Variable Lowpass controls
2Ch & 4Ch
Adjust the crossover frequency of the LOW Pass output only, from 30Hz to 500Hz.
Mono Ch
Adjust the crossover frequency of the LOW Pass from 50Hz to 250Hz.
Variable Phase shift
Variable Phase shift 0 to 180
Amplifier X-over switch / Line outs X-over switch for 2Ch & 4Ch
a) LPF : Allows for the control of the low pass frequency range
(30Hz-500Hz) by using the Low Variable Control.
b) FULL : Allows for full range pass through.
c) HPF : Allows for the control of the high pass frequency range
(30Hz-500Hz) by using the High Variable Control.
LINKABLE OPERATION (MASTER / SLAVE MODE)
You can bridge 2amp and make bigger output
a) Connect Master & Slave amp thru RCA (Master === Slave)
b) Master Amp : place the S/W to Master position
c) Slave Amp : place the S/W to Slave position
d) You can connect the speaker wire from Mster + (Speaker +) & Slave + (Speaker -)
Power LED
lt indicates when amplifier is on and no fault existence.
Protection LED
lt illuminates when fault condition exists, and amplifier immediately shuts down.
lf illuminated, turn amplifier off, check for shorted speaker leads and DC noise
from RCA input and attempt to re-power amplifier.
Speaker Terminal
It allows the connection of speakers to the amplifier.
Fuse
It protects both the amplifier and automobile electrical system from fault conditions.
Power connection
Connects +12VDC power wire from the battery.
Remote connection
Connects the control wire which allows the amplifier to be turned on and off by the
radio cassette player.
Connects ground wire from a suitable ground point on the chassis.
Remote Gain Control
you can control Remote Gain, conneeting the Remote control to Amplifier.
- 10 -
Advertisement
