Panelcmd Command - Matrix Switch Corporation MSC-2HD1624S Product Manual

NOTE: Superseded by
I/O pairing is used for pairing destinations/sources for 3D support. When activated a router will appear to have
half the number of physical destinations and sources. A given matrix crosspoint change will cause 2
destinations to be changed. Each odd destination/source is paired with the next highest even number
destination/source. This option is stored and recalled on power on. When enabling this feature on a 4x4 video
router for example, it would appear as a 2x2 3D router where destination 1 & 2 are paired and 3 & 4 are paired,
likewise for sources. This setting is stored and recalled on power up.
Command
PairIO
PairIO 0 | 1
Example
>PairIO
0
>PairIO 1
>
The first command queries the current state of I/O pairing, the second enables it.

3.11.24 PanelCmd Command

Protocol Version: 3.0
Query and assign panel button/GPIO command macros. This system provides a means to easily implement
custom functionality in response to a panel button press or GPIO auxiliary port contact closure (button or switch
to ground). Panel buttons and GPIO pins are specified by numeric ID.
Panel buttons are numbered beginning with ID number 1. Panel button order depends on the panel, but
generally has the top left button as button 1, followed by number 2 in the lower left corner, number 3 in the top
second column, continuing to alternate between top and bottom rows till the last button (lower right hand
corner).
GPIO auxiliary pins start with ID number 65 for GPIO pin 1.
NOTE: Panel commands must be enabled with the
P arameter to activate them.
Command
PanelCmd
PanelCmd Button
PanelCmd Button Command
Page 38 of 60
MSC-2HD1624S Product Manual
MtxGroup C ommand .
Description
Query current value of I/O pairing configuration.
Enable or disable I/O pairing (0: disable, 1: enable)
Description
Query all assigned panel button/GPIO commands.
Query a single panel button/GPIO command.
Assign a panel button/GPIO command. Assigning a blank command to a
button or GPIO pin will clear the command (two consecutive single or double
quotes represents an empty string).
© 2013-2018 Matrix Switch Corporation
PanelCmdEn Command or by setting the pnl.cmdEn
www.matrixswitch corp.com
S ystem