Advertisement
Quick Links
ASSEMBLY AND INSTALLATION
T0169 / T0345
WARNING:
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
Mounting Strap (A)
Important to Know:
1. If you are not familiar with state and local electrical
codes, it is recommended that you consult with a
qualified electrician.
2. This fixture requires a 110~120 VAC, 60 Hz power
source.
3. For general safety and to avoid any possible
damage to the sensor, be sure the power is
switched "off" before adjustment.
Maximum Wattage: 34 W
Working Temperature Range: -4
Note: Fixture can be wall mounted or eave mounted.
Wall Mounted
Light fixture and sensor should be mounted as shown above when installed (depending upon type of installation)
Before installing the light fixture under an eave, the sensor head must be rotated as shown in the next two steps for
proper operation and to avoid the risk of electrical shock.
For eave mounted only:
Swing the sensor head towards the back plate
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Mounting Screw (B)
0 F ~ 113 0 F
Back Plate
Controls
Page 1 / 5
Decorative cover (C)
Features:
1. Energy saving LED fixture.
2. Motion sensor: turns light ON automatically when
motion is detected and turns light OFF automatically
when motion stops.
3. Photocell keeps the light OFF during daylight hours.
4. When in manual override mode, use wall switch
to keep the light ON during the night.
Eave Mounted
Rotate the sensor head clockwise 180˚ so the controls face down.
Controls
Wire Connector (D)
Controls
150105
Advertisement
Related Manuals for Quoizel T0169
Summary of Contents for Quoizel T0169
- Page 1 ASSEMBLY AND INSTALLATION INSTRUCTIONS T0169 / T0345 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
-
Page 2: Installation Steps
FRONT Light Head Outlet Box Decorative cover (C) Mounting Strap (A) Sensor Wire Connector (D) Back Plate Installation Steps Turn off the power at fuse or circuit box. 1. Install the mounting strap to the outlet box with the stamped word “FRONT” facing away from the outlet box, using two mounting screws that best fit the outlet box. -
Page 3: Adjusting The Light Head
Sensitivity of Motion Sensor ● You can adjust the sensitivity of the motion sensor by using the “SENSITIVITY” selector located on the right side of the bottom surface of the sensor. (See Fig. 4) ● Adjust motion sensor sensitivity to achieve desired performance. ●... -
Page 4: Customization Options
Customization Options: Shut-off Delay 1. The shut-off delay is the length of time the light will stay at brightness after motion has ceased to be detected. 2. You can set the shut-off delay by rotating the delay time knob arrow so it points to the desired time setting within “TIME”... - Page 5 The following parts are available for re-order if damaged or missing. Spare Parts List: Mounting Hardware 5305MM for T0169 5743MM for T0345 Mounting Strap (A) Mounting Screw (B) Decorative cover (C) Wire Connector (D) 5-YEAR LIMITED WARRANTY: All products are warranted to be free of defects in material and workmanship for five (5) years from date of purchase.