Receiving Rds Broadcasts - Sony FST-SH2000 Operating Instructions Manual

1
Press TUNER/BAND repeatedly to
select AM band.
2
Press "/1 to turn off the system.
3
While holding down ENTER, press
"/1.
"AM 9K STEP" or "AM 10K STEP"
appears in the display panel.
When you change the interval, all the
AM preset stations are erased.
Presetting radio stations
You can store up to 20 FM and 10 AM
stations as your favorite stations.
Use the buttons on the remote control to
perform this operation.
1
Tune to the station you want.
2
Press TUNER MEMORY.
3
Press +/– repeatedly to select
the preset number you want,
then press ENTER.
"COMPLETE" appears in the display
panel. The station is stored.
To tune to a preset station
Press TUNING MODE repeatedly until
"PRESET" lights up in the display panel.
Then, press +/– repeatedly to select the
preset number you want.
Receiving RDS
broadcasts
This system allows you to use Radio Data
System (RDS), which enables radio
stations to send additional information
along with the regular programming
signal. This system offers convenient
RDS features, such as Program Service
name display. RDS is available only for
FM stations.*
* Not all FM stations provide RDS service, nor
Simply select a station on the FM
band.
When you tune to a station that provides
RDS services, the Program Service name
appears in the display panel.
You can check the RDS information by
pressing DISPLAY on the remote control
repeatedly.
Preset number
Note
RDS may not work properly if the station you
tuned to is not transmitting the RDS signal or if
the signal strength is weak.
do they provide the same type of services. If
you are not familiar with the RDS services in
your area, check with your local radio stations
for details.
GB
13