Table of Contents
Advertisement
2. Select your option. Tap on
select or unselect.
3. Tap on
Done
to finish setting.
Switch between different displays
• Slide the bar below displays.
• Or, tap on
/
.
Status pull-down menu
By dragging
at the top of the idle screen,
you can quickly turn on/off the alarm, GPRS
connection, Bluetooth, or silent mode; check
battery level; and select your desired profile, or
ring type for incoming calls or messages.
Stylus
The touch screen allows you to enter text by
directly writing on the screen, or tap to select
the desired option. The supplied stylus makes it
easier to do so.
The first time you switch on the phone, you are
asked to do calibration for the stylus. Thus,
6
Select/Cancel
to
strokes or taps by the stylus will be precisely
displayed on the screen.
You can also do the calibration in
General
>
Pen calibration
instructions.
Sensor
With built-in motion and light sensors, the
phone can react to motion and ambient
luminance as desired or necessary.
To use the motion sensor
• In
Settings
>
General
incoming call
or
Snooze
If a call rings, turn over the phone (front side to
back, or back side to front) to mute the
ringtone.
To interrupt the sounding alarm in the same
way, check that the
interval in
Tools
>
Alarm
on page 42). To stop the alarm, tap on Stop.
Settings
by following the screen
>
Motion sensor
>
alarm, select On.
Snooze
is set to a time
(see "To set an alarm"
>
Mute
Advertisement
Table of Contents
