Maintenance; Troubleshooting - Philips AZB500W User Manual

Hide thumbs Also See for AZB500W:
Table of Contents

Advertisement

Maintenance

Clean the cabinet
Use a soft cloth slightly moistened with
a mild detergent solution. Do not use a
solution containing alcohol, spirits, ammonia
or abrasives.
Clean discs
When a disc becomes dirty, clean it with
a cleaning cloth. Wipe the disc from the
centre out.
Do not use solvents such as benzene,
thinner, commercially available cleaners,
or antistatic spray intended for analogue
records.
Clean the disc lens
After prolonged use, dirt or dust may
accumulate at the disc lens. To ensure good
play quality, clean the disc lens with Philips
CD lens cleaner or any commercially
available cleaner. Follow the instructions
supplied with cleaner.

9 Troubleshooting

Warning
Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support). When you contact Philips,
make sure that the device is nearby and the
model number and serial number are available.
No power
Ensure that the Mains cord is connected
securely.
Ensure that there is power at the AC
Mains.
Ensure that the batteries are inserted
correctly.
No sound or poor sound
Adjust the volume.
No response from the unit
Disconnect and reconnect the AC power
plug, then turn on the system again.
As a power-saving feature, the unit
switches off automatically 15 minutes after
track play reaches the end and no control
is operated.
No disc detected
Insert a disc.
Check if the disc is inserted upside down.
Wait until the moisture condensation at
the lens has cleared.
Replace or clean the disc.
Use a finalized CD or correct format disc.
EN
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Azb500bAzb500w/12Azb500b/12

Table of Contents