Gigabyte GA-A320M-S2H V2 User Manual page 15

6) M2F_32G (M.2 Socket 3 Connector)
The M.2 connector supports M.2 SATA SSDs or M.2 PCIe SSDs and supports SATA RAID configuration.
Please note that an M.2 PCIe SSD cannot be used to create a RAID array. Refer to Chapter 3, "Configuring
a RAID Set," for instructions on configuring a RAID array.
110 80
Follow the steps below to correctly install an M.2 SSD in the M.2 connector.
Step 1:
Use a screw driver to unfasten the screw and standoff from the motherboard. Locate the proper mounting
hole for the M.2 SSD to be installed and then screw the standoff first.
Step 2:
Slide the M.2 SSD into the connector at an angle.
Step 3:
Press the M.2 SSD down and then secure it with the screw.
Select the proper hole for the M.2 SSD to be installed and refasten the screw and standoff.
Installation Notices for the M.2 Connector:
Supports only M.2 SATA SSDs when using an AMD 7th Generation A-series or Athlon
to the following table for details.
Type of M.2 SSD
CPU
Ryzen processor
™
7th Generation A-series/Athlon processors
™
a: Available, r: Not available
7) SPDIF_O (S/PDIF Out Header)
This header supports digital S/PDIF Out and connects a S/PDIF digital audio cable (provided by expansion
cards) for digital audio output from your motherboard to certain expansion cards like graphics cards and
sound cards. For example, some graphics cards may require you to use a S/PDIF digital audio cable for
digital audio output from your motherboard to your graphics card if you wish to connect an HDMI display
to the graphics card and have digital audio output from the HDMI display at the same time. For information
about connecting the S/PDIF digital audio cable, carefully read the manual for your expansion card.
_ 0 F
60 42
_3 U
M.2 PCIe SSD
a
r
Pin No. Definition
1
1
2
- 15 -
processor. Refer
™
M.2 SATA SSD
a
a
SPDIFO
GND