ELC DT2110 User Manual

Dmx tool splitter 2 to 10

Advertisement

Quick Links

DMX Tool Splitter 2 to 10
User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DT2110 and is the answer not in the manual?

Questions and answers

Summary of Contents for ELC DT2110

  • Page 1 DMX Tool Splitter 2 to 10 User Manual...
  • Page 2 __________________________________________________________________________________ ELC DT2210 User Manual...
  • Page 3 DMX Tool Splitter 2 to 10 User Manual The ELC DT2210 is a 19” rackmount DMX splitter supporting the bidirectional extension to the DMX protocol to accommodate Remote Device Management (RDM). The DT2210 is used in larger DMX networks where more than simple daisy-chain connections between multiple DMX devices (to a maximum of 32 devices) are needed.
  • Page 4 Functional overview The ELC DT-2210 DMX / RDM splitter is a flexible DMX splitter with support for the bidirectional extension to the DMX protocol called Remote Device Management (RDM). Normal DMX cabling has to be done in daisy chain connection, meaning the DMX connection goes from the DMX source (console) to the first device, then to the next device, and so on.
  • Page 5 A USB connector and a small red switch are located on the back of the DT-2210. These come into play when firmware updates become available which are periodically published on the ELC Lighting website (www.elclighting.com). The USB Update software, which is needed to perform the firmware upgrade, is also available for download on the website.
  • Page 6 In all of the previous conditions, disconnect the main plug immediately and call your distributor or technical support! __________________________________________________________________________________ ELC DT2210 User Manual...
  • Page 7 WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE __________________________________________________________________________________ ELC DT2210 User Manual...
  • Page 8 With the presumption that the equipment is used and connected according to the manual, supplied with the equipment. All signal input- and output connections must be shielded and the shielding must be connected to the ground of the corresponding plug. Gemert, February 16, 2018 ing. Joost van Eenbergen __________________________________________________________________________________ ELC DT2210 User Manual...

This manual is also suitable for:

Dt2210fi

Table of Contents