Related Manuals for Jet JAT-801
Summary of Contents for Jet JAT-801
- Page 1 Pneumatic Needle Scaler #505801, JAT-801 Operation & Parts Manual M-505801 Edition 3 11/2018 427 New Sanford Road LaVergne, TN 37086 Ph.: 800-274-6848 www.jettools.com Copyright © 2015 JET...
-
Page 2: Warranty And Service
Shop Tools; Warehouse & Dock products; Hand Tools; Air Tools NOTE: JET is a division of JPW Industries, Inc. References in this document to JET also apply to JPW Industries, Inc., or any of its successors in interest to the JET brand. -
Page 3: Safety Warnings
15. Excessive air pressure and too much free Do not use this tool for other than its intended rotation may decrease life of the tool and may use. If used for other purposes, JET disclaims cause a hazardous situation. any real or implied warranty and holds itself 16. - Page 4 To reduce 32. Do not lubricate the tool with combustible your exposure to these chemicals, work in a liquids, such as kerosene, diesel or jet fuel. well-ventilated area and work with approved 33. Do not dispose of this tool with normal safety equipment, such as dust masks that are household waste.
-
Page 5: About This Manual
As with any tool operation, safety of operator and bystanders should be first priority. If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our web site: www.jettools.com. -
Page 6: Tool Specifications
Specifications were current at time of publication, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations. -
Page 7: Setup And Assembly
Setup and Assembly hole in collar. Any missing parts or damage should be reported Insert needle shank into cylinder, aligning immediately to your JET ® distributor. Do not use a notch in shank with ball. damaged tool. Read this instruction manual... -
Page 8: Maintenance
Tool Pressure Air system requirements JET Air Tools operate on 70-to-100 psi (pounds per square inch) air pressure measured at the tool Use proper air hose size (refer to tool when the tool is operating. Set tool to 90 psi specifications). - Page 9 Lubrication Use a light oil containing rust inhibitors, such as SAE #10. Many JET air tools have integral oil reservoirs, which should be kept filled when in-line oilers are not used. Figure 2...
- Page 10 Troubleshooting JAT-801 Needle Scaler Any disassembly of the tool should be done by qualified service personnel. For problems not addressed below, contact JET technical service at 800-274-6846. Problem Possible cause Remedy Tool will not start. Air valve closed or obstructed.
- Page 11 #505801, JAT-801, Needle Scaler – parts breakdown Index Part No. Description Index Part No. Description F25-01 Cylinder cap 17 F25-17 Lock ring F25-02 Throttle bushing 18 SB-7/16 Steel ball 7/16in. F25-03 Throttle rod 19 F25-19 O-Ring 23.7x3.5 F25-04 O-Ring 3.8x1.9...
-
Page 12: Replacement Parts
5:00 p.m. CST. Please have the stock number and serial number of your tool available when you call, so that we may serve you quickly and accurately. 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.jettools.com JAT-801 Pneumatic Needle Scaler...