Accessories; Shop Tools; Warehouse & Dock products; Hand Tools NOTE: JET is a division of JPW Industries, Inc. References in this document to JET also apply to JPW Industries, Inc., or any of its successors in interest to the JET brand.
15. Excessive air pressure and too much free Do not use this tool for other than its intended rotation may decrease life of the tool and may use. If used for other purposes, JET disclaims cause a hazardous situation. any real or implied warranty and holds itself 16.
Page 4
To reduce 32. Do not lubricate the tool with combustible your exposure to these chemicals, work in a liquids, such as kerosene, diesel or jet fuel. well-ventilated area and work with approved 33. Do not dispose of this tool with normal safety equipment, such as dust masks that are household waste.
As with any tool operation, safety of operator and bystanders should be first priority. If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our web site: www.jettools.com.
Specifications were current at time of publication, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations.
Setup and Assembly and install any quick-change couplings farther down the line. Any missing parts or damage should be reported immediately to your JET ® distributor. Do not use a Note: For best results, prepare work surface by damaged tool. Read this instruction manual...
Page 8
(See also “Troubleshooting” Use a light oil containing rust inhibitors, such as section.) SAE #10. Many JET air tools have integral oil reservoirs, which should be kept filled when in-line Contaminated air such as a dirty air system oilers are not used.
Page 9
Figure 2 Recommended arrangement of air piping and air line system...
Page 10
Troubleshooting JAT-800 Needle Scaler Any disassembly of the tool should be done by qualified service personnel. For problems not addressed below, contact JET technical service at 800-274-6846. Problem Possible cause Remedy Tool will not start. Air valve closed or obstructed.
Replacement parts Service parts are listed on the following pages. To order parts or reach our service department, call 1-800- 274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Please have the stock number and serial number of your tool available when you call, so that we may serve you quickly and accurately.
Page 13
#505800, JAT-800, Needle Scaler – parts list Index Part No. Description Index Part No. Description 730213 Back head 729606 Front valve block 729591 O-Ring 3.2x1.9 730219 Piston 730214 Throttle valve 731008 Barrel sleeve 730214-1 O-Ring 3.5x1.5 731009 Nose 730215 Spring...
Page 14
This page intentionally left blank. JAT-800 Pneumatic Needle Scaler...