LG LT-D4880RJ Owner's Manual page 7

Wireless Remote Controller (optional)
This air-conditioner is equipped with wired remote controller basically. But if you want to be available with
wireless remote controller, you pay for it.
Signal transmitter
(Transmits the signals to the signal receptor)
3
12
13
4
5
SET
6
Heat Pump
14
Model
Cooling Model
• Aim at the signal receptor on the wired remote controller so as to operate.
• The remote control signal can be received at a distance of up to about 7m.
• Be sure that there are no obstructions between the remote controller and the signal receptor.
• Do not drop or throw the remote controller.
• Do not place the remote controller in a location exposed to direct sunlight, or near the heating unit, or any
other heat source.
• Block a strong light over the signal receptor with a curtain or etc. so as to prevent the abnormal operation.
(ex:electronic quick start, ELBA, inverter type fluorescent lamp)
1
7
2
ON OFF
8
9
CANCEL
10
PLASMA
15
11
Flip-up door
(opened)
CAUTION
of handling the Remote Controller
OPERATION DISPLAY
1
Displays the operation conditions.
ON/OFF BUTTON
2
Operation starts when this button is pressed and stops
when the button is pressed again.
JET COOL BUTTON
3
Used to select jet cool mode.
ON/OFF TIMER BUTTONS
4
Used to set the time of starting and stopping operation.
TIME SETTING BUTTONS
5
Used to adjust the time.
TIMER SET/CANCEL BUTTONS
6
Used to set the timer when the desired time is obtained
and to cancel the Timer operation.
AIR SWING BUTTON
7
Used to swing up and down.
SLEEP MODE BUTTON
8
Used to set Sleep Mode Auto operation.
AIR CIRCULATION BUTTON
9
Used to circulate the room air without cooling or heating
(turns indoor fan on/off).
ROOM TEMPERATURE CHECKING BUTTON
10
Used to check the room temperature.
RESET BUTTON
11
Used prior to resetting time or after replacing batteries.
INDOOR FAN SPEED SELECTOR
12
Used to select fan speed in four steps-low, medium,
high, or CHAOS.
ROOM TEMPERATURE SETTING BUTTONS
13
Used to select the room temperature.
ORERATION MODE SELECTION BUTTON
14
Used to select the operation mode.
PLASMA AIR CLEAN BUTTON(OPTIONAL)
15
7