Connecting With A Component Cable - LG 22LD320H Owner's Manual

exteRnAl equIPment setuP
■ To avoid damaging any equipment, never plug in any power cord until you have finished connecting
all equipment.
■ This section on exteRnAl equIPment setuP mainly uses diagrams for the 32LD3 *** models.
■ Image shown may differ from your TV.

ConneCtIng WIth A ComPonent CABle

This TV can receive Digital RF/Cable signals without an external digital set-top box. However, if you do
receive Digital signals from a digital set-top box or other digital external device, refer to the diagram as
shown below.
Connect the video outputs ( Y, P
1
external equipment (digital set-top box, DVD,
etc.) to the ComPonent In VIdeo jacks on
the TV.
Connect the audio output of the external equip-
2
ment (digital set-top box, DVD, etc.) to the
ComPonent In AudIo jacks on the TV.
Turn on the external equipment.
3
( Refer to the external equipment's manual for
operating instructions.)
Select the Component input source using the
4
InPut button on the remote control.
► HDMI Audio Supported format : Dolby Digital, PCM
DTS Audio format is not supported.
Signal
480i/576i
480p/576p
720p/1080i
1080p
Component Input ports
To achieve better picture quality, connect a DVD player to the component input ports as shown below.
Component ports on the TV
Video output ports
on DVD player
2
) of the
, P
B R
Component
O
O
O
O
(24 Hz / 30 Hz /
(50 Hz / 60 Hz only)
50 Hz / 60 Hz)
Y
Y
Y
Y
Y
/DVI IN
HDMI
X
O
O
O
P P
B R
P P
B R
B-Y R-Y
Cb Cr
Pb Pr
(RGB)
1
2
1
2
VOLUME CONTROL
STEREO
(8 ) ANTENNA
IN
SPEAKER
OUT