Checking Lamp Time; Using Still Function; Screen Menu Options; Auto Configure Function - LG BX403B Owner's Manual

Function

Checking lamp time

1. Press the MENU button and then use
menu.
2. You can check lamp usage hours
• Red warning lamp will light when it needs to be replaced. (Please refer page 10)
• When lamp usage hour exceeds the limit, red warning lamp is lit when the power
is turned on.
• Press the MENU button twice or the EXIT button to exit the menu screen

Using Still Function

1. Press the STILL button of remote control.
• You can freeze the input image.
<Moving Image>
2. To exit STILL, press any button .
• The STILL function will release automatically after approximately 10 minutes.

Screen Menu Options

Auto configure Function

* Auto configure is the function that finds optimal video condition by automatically adjusting width and calibration of internal
signal of the projector and various graphic signal of PC in RGB mode.
* Auto configure operates only for RGB input.
1. Press the MENU button and then use ＜, ＞ button to select the
2. Press the ∧,∨ button to select auto configure.
• It automatically configures the location of image and calibration.
3. In some cases, auto configure itself cannot find optimal video quality.
If it needs manual adjustment even after auto configure due to various PC mode
input, adjust using phase, clock, horizontal and vertical from the menu.
When executing auto configure during video playback of PC graphic signal, the projector may not be
able to find optimal video condition. Please execute auto configure in freeze frame.
30
button to select the
＜, ＞
<Still Image>
menu.
Keystone
Blank Image
＜
Screen Capture
Lamp mode
＜
Monitor Out
＜
Communication
＜
Set ID
＜
Network Setting
＜
High Altitude
Lamp Time
ꕌ
ꘀ
Prev. Move
ꕍ
Auto Configure
Phase 8
Clock 0
Horizontal 0
Vertical 0
ꕌ
ꘀ
Prev. Move
ꕍ
＞
Black
High bright ＞
＞
RGB1
＞
Serial
＞
1
＞
Auto
0 Hr
Select
＜＞
◉ OK