Mitsubishi AL-232CAB Hardware Manual page 33

α
Simple Application Controller
Table 6.2: Function Block Description
Function Block
NOR
NOT
BOOLEAN
SET/RESET
DELAY
ONE SHOT
PULSE
FLICKER
ALT
COUNTER
U/D COUNTER
COMPARE
TIME SWITCH
OFFSET GAIN
DISPLAY
ZONE COMPARE
SCHMITT TRIGGER
HOUR METER
System Outputs
*Number of bytes varies with input data.
Byte
Not OR; Output Off when at least one Input is On, Unused inputs considered
19
Off
10 Inverts a signal; changes an Off to an On and vice versa
* Logic equation using AND, OR, XOR, and NOT
14 Latch a relay in SET or RESET position, give Set or Reset priority
19 Delay a signal on the Rising, Falling, or both Edges
17 Send a single pulse; Time or Input signal based, Reset pin available
10 Send a Pulse on the Rising, Falling, or both Edges
19 Send a pulse train; On/Off times, repetitions, duration, or continuous operation
13 Output alternates turning On or Off with each input pulse
16 Count upwards on pulses, can reset at an input value or signal
22 Up and Down Counter with Preset Input and Clear functions
17 Compare two values for <,>,=,<=,>=,<> (Analog, Direct Set, or FB values)
* Use the RTC to turn output On/Off; Calendar or weekly schedule
22 Manipulate Analog Values; y = A/B*x + C; Set High and Low Limit Values
* Display Messages or Data on the LCD display
20 Compare a value to a range of values (Analog, Direct Set, or FB values)
19 Turn an Input On at the High Value and Off at the Low Value (or vice versa)
19 Records the accumulated time an Output or Input signal has been ON
10 Controls External Devices through Relays and Transistors.
How to Use α α α α Series Controllers - Getting Started 6
Description
ENG
27