Acer H6820M User Manual page 38

28
Power AC Power On
Choose "On" to power on projector while AC power plug in.
Auto Shutdown (Minutes)
The projector will automatically shutdown when there is no signal
input after the allocated time. (default is 20 minutes)
Sleep Time (Minutes)
Sets the sleep timer.
Network Standby
•
•
•
Management Test Pattern
Default is "Off" to disable this function or select the test pattern
from Grid (Green), Grid (Magenta), Grid (White), White.
Projection
•
•
•
•
HDMI EDID
Select the HDMI EDID type from 2.0 or 1.4
Source Selection
Select source detection information from Notification, Manual or
Auto.
High Altitude
Choose "On" to turn on High Altitude mode. Operate the fans at
full speed continuously to allow for proper high altitude cooling of
the projector.
Auto Screen
Default is "Off" , the down/up move of electronic screen will be
related with power on/off of Projector.
Note: Functions vary depending on model definition.
Off: Default is "Off".
LAN: Choose "LAN" to enable LAN control under standby
mode.
WiFi: Choose "WiFi" to enable WiFi control under standby
mode.
Front: The factory default setting.
Rear: When you select this function, the projector reverses the
image so you can project from behind a translucent screen.
Rear Ceiling: When you select this function, the projector
reverses and inverts the image at same time. You can project
from behind a translucent screen with ceiling mounted
projection.
Ceiling: When you select this function, the projector inverts
the image for ceiling-mounted projection.