Disassembly And Assembly; Introduction - ABB HT611169 Operation Manual

Operation Manual / TPL65-A32 / -A33 / -A36 + TPL69-A32 / -A33
8 Disassembly and assembly / 8.1 Introduction

8 Disassembly and assembly

8.1 Introduction

© Copyright 2020 . All rights reserved.
CAUTION
Working on the cartridge group
For safety and product liability reasons, work on the cartridge group
that is not described in the operation manual should only be carried out
by trained specialists at an ABB Turbocharging Service Station.
Unqualified work on the cartridge group can lead to total system
u
failure and void the warranty.
Mark the casing position for assembly.
u
Identifying assembly devices
Not all assembly devices are marked with a part number. They can be
identified using the tool list. This list is enclosed in the toolbox.
WARNING
Maintaining assembly devices
Assembly devices must be checked for damage before and after use.
Check visually for corrosion, cracks, deformation and wear.
u
Don't use damaged assembly devices, but replace them.
u
Customer spare part set
Before beginning work, ensure that the required customer spare part
sets are available.
See chapter Spare parts.
u
HZTL2498_EN Rev.F December 2020