Page 1
User’s Guide ake sure to read the before using the product. Keep the User's Guide(CD) in an accessible place for furture reference. ee the label attached on the product and give the information to your dealer when you ask for service.
Page 2
On Safety Use only the power cord supplied with the unit. In case you use another power cord, make sure that it is certified by the applicable national standards if not being provided by the supplier. If the power cable is faulty in any way, please contact the manufacturer or the nearest authorized repair service provider for a replacement.
Page 3
On Installation Do not allow anything to rest upon or roll over the power cord, and do not place the display where the power cord is subject to damage. Do not use this display near water such as near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool.
Connecting the speaker Place the monitor with its front facing downward on a soft cloth. Insert the protruding hook of the speaker in the direction of the slot in the back of the product. After setting up the speaker, connect the Audio DC-In Cable to the back of the product. AC-IN DC-OUT D-SUB...
Connecting the stand Place the monitor with its front facing downward on a soft cloth. Assemble the Stand Body into the product in the correct direction as shown in the picture. Make sure you push it until you hear it “click”. Assemble the Stand Base(Front, Rear) into the Stand Body in the correct direction.
Positioning your display Adjust the position of the panel in various ways for maximum comfort. Warning: When adjusting height of the monitor, do not put your fingers between monitor and stand bottom. You may hurt your fingers. A7 A7...
Page 9
Positioning your display Note: When you use speakers, be sure to set up the stop cover first as shown. Then you use height function, the speakers will not touch the base cover. Stop cover is only for speaker models - L1753HM, L1953HM Warning: When adjusting height of the monitor, do not put your fingers between monitor and...
Using the Computer Place the monitor in a convenient, well-ventilated location near your computer. Connect the signal cable. When attached, tighten the thumbscrews to secure the connection. Connect the power cord into a proper power outlet that is easily accessible and close to the display.
Page 11
Side Jack *Line Out Speaker Out <Jack of the PC sound card>...
Screen Adjustment Allow the display to stabilize for at least 30 minutes before making image adjustments. To make adjustments in the On Screen Display, follow these steps: Press the MENU Button, then the main menu of the OSD appears. To access a control, use the becomes highlighted, press the AUTO/SET Button.
Page 15
The order of icons may differ depending on the model (A14~A18).
Page 16
OSD (On Screen Display) menu languages on the monitor may differ from the manual.
Signal Connector Pin Assignment DVI-D Connector Signal(DVI-D) T. M. D. S. Data2- T. M. D. S. Data2+ T. M. D. S. Data2/4 Shield T. M. D. S. Data4- T. M. D. S. Data4+ DDC Clock DDC Data Analog Vertical Sync. T.
Page 29
Place the monitor with its front facing downward on a soft cloth. Separate the stand after firstly separating 6 screws by using a driver as figure. Install the Wall mount plate.