Samsung WF45T6000A Series User Manual page 25

(*): Min. 6 in. (152 mm), Max. 8 in.
(203 mm)
STEP 6 Remove the film inside the door
B
STEP 7 Power on
Plug the power cord into an AC 120 V / 60 Hz / 15 AMP approved electrical outlet
protected by a fuse or circuit breaker. Then, press Power to turn on the washer.
Untitled-31 25
A
*
A A
3. Route the drain hose to the drain
system.
CAUTION
• If using a standpipe, make sure the
standpipe and drain hose connection is
not airtight.
• If using a standpipe, make sure the
drain hose is inserted at least 6 in.
(152 mm) but no more than 8 in.
(203 mm) into the standpipe.
4. Secure the drain hose with cable ties.
Over the edge of a wash basin
The drain hose must be placed no lower
than 24 in. (60 cm) and no higher than
35 in. (90 cm) from the floor. To keep
the spout of the drain hose bent, use the
supplied plastic hose guide (A). Secure the
guide to the wall using a hook to ensure
stable drainage.
Remove the small circle of film (B) above
the door latch before use.
English 25
2020-03-02 PM 3:19:38