Table of Contents
Advertisement
LPC Header
(19-pin LPC1)
(see p.8, No. 23)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.8, No. 26)
1. High Definition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow
the instructions in our manual and chassis manual to install your
system.
2. If you use an AC'97 audio panel, please install it to the front panel
audio header by the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to
OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. To activate the front mic.
For Windows
Select "Mixer". Select "Recorder". Then click "FrontMic".
For Windows
Vista
Go to the "FrontMic" Tab in the Realtek Control panel. Adjust
"Recording Volume".
OUT_RET
MIC_RET
PRESENCE#
GN D
1
®
XP / XP 64-bit OS:
®
8.1 / 8.1 64-bit / 8 / 8 64-bit / 7 / 7 64-bit /
TM
TM
/ Vista
64-bit OS:
This connector supports
Trusted Platform Module
(TPM) system, which can
securely store keys, digital
certificates, passwords, and
data. A TPM system also
helps enhance network se-
curity, protects digital identi-
ties, and ensures platform
integrity.
This is an interface for the
front panel audio cable that
OUT2_L
J_SENSE
allows convenient connec-
OUT2_R
MIC2_R
tion and control of audio
MIC2_L
devices.
18
Advertisement
Table of Contents
