Table of Contents
Advertisement
•
Constant bit rate:
•
MP3: 112 kbps - 320 kpbs
•
WMA: 48 kpbs - 192 kpbs
USB
•
Compatibility: Hi-Speed USB (2.0)
•
Class support: USB Mass Storage Class
•
File system: FAT16, FAT32
•
USB port: 5V
, 500mA (for each port)
•
Support HDD (a portable hard disc drive):
an external power source may be needed.
Main unit
•
Power supply rating: 100-240V~, 50-60 Hz
•
Power consumption: 16 W
•
Power consumption in standby mode (fast
wakeup disabled): < 0.5 W
•
Dimensions (w x h x d): 360 x 42 x 219
(mm)
•
Net Weight: 1.18 kg
Accessories supplied
•
Remote control and batteries
•
User manual
•
AC power cord
Laser Specification
•
Laser Type (Diode): AlGaInN (BD), AlGaInP
(DVD/CD)
•
Wave length: 405+7nm/-7nm (BD),
660+10nm/-10nm (DVD), 785+10/-10nm
(CD)
•
Output power: 1mW (BD), 0.26mW
(DVD), 0.3mW (CD)
Operating Temperature & Humidity
•
0°C to 45°C, 5% to 90% Humidity for
all climates.
Storage Temperature & Humidity
•
-40 °C to 70 °C, 5% to 95%
6 Troubleshooting
Note
•
For identification and supply ratings, see the type plate
at the back or bottom of the product.
•
Before you make or change any connections, make sure
that all devices are disconnected from the power outlet.
Warning
•
Risk of electric shock. Never remove the casing of the
player.
To keep the warranty valid, never try to repair
the player yourself.
If you have problems using this player, check the
following points before you request service. If
you still have a problem, register your player and
get support at www.philips.com/support.
If you contact Philips, you will be asked for the
model and serial number of this player. The
model number and serial number are on the
back of this player. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Main unit
The buttons on this player do not work.
•
Disconnect this player from the power
supply for a few minutes, and then
reconnect.
Picture
No picture.
•
Make sure that the TV is switched to the
correct source input for this player.
•
For the composite connection (via the
VIDEO connector) to the TV, on this player
select a video resolution of 480i/576i or
480p/576p to enable video output (press
, and select [Setup] > [Video] > [HDMI
video]) .
No picture on HDMI connection.
•
Make sure that the HDMI cable is not
faulty. If it is faulty, replace with a new
HDMI cable.
EN
21
Advertisement
Table of Contents
