Connecting With A Component Cable - LG 37LE5300 Owner's Manual

external equiPment SetuP
■ To avoid damaging any equipment, never plug in any power cord until you have finished connecting
all equipment.
■ This section on external equiPment SetuP mainly uses diagrams for the 32/37/42/47LD4 ***
models.
■ Image shown may differ from your TV.

ConneCting With a ComPonent CaBle

This TV can receive Digital RF/Cable signals without an external digital set-top box. However, if you do
receive Digital signals from a digital set-top box or other digital external device, refer to the diagram as
shown below.
Connect the video outputs ( Y, P
1
external equipment (digital set-top box, DVD,
etc.) to the ComPonent in Video jacks on
the TV.
Connect the audio output of the external equip-
2
ment (digital set-top box, DVD, etc.) to the
ComPonent in audio jacks on the TV.
Turn on the external equipment.
3
( Refer to the external equipment's manual for
operating instructions.)
Select the Component input source using the
4
inPut button on the remote control.
► HDMI Audio Supported format : Dolby Digital, PCM
DTS Audio format is not supported.
Signal
480i/576i
480p/576p
720p/1080i
1080p
Component input ports
To achieve better picture quality, connect a DVD player to the component input ports as shown below.
Component ports on the TV
Video output ports
on DVD player
2
) of the
, P
B R
Component
O
O
O
O
(24 Hz / 30 Hz /
(50 Hz / 60 Hz only)
50 Hz / 60 Hz)
Y
Y
Y
Y
Y
HDMI
X
O
O
O
P P
B R
P P
B R
B-Y R-Y
Cb Cr
Pb Pr
1
2
or
1
2