Table of Contents
Advertisement
Available languages
Available languages
CAUTION FOR USING EzSign 2.0
For LN549E series
Do not remove a USB drive while data is being copied. It can corrupt the data and EzSign may not work properly.
y
y
While loading a USB device or dongle, your TV may function slower than normal.
y
y
Some user-created subtitles may not work properly.
y
y
Some special characters are not supported in subtitles.
y
y
HTML tags are not supported in subtitles.
y
y
Subtitles in languages other than the supported languages are not available.
y
y
EzSign 2.0 TV function does not work before completing the initial setup Wizard. Make sure to complete the initial
y
y
setup Wizard by turning on the TV after installation.
If the time is set according to the TV signal, it may not appeared exactly for some region. In that case, set the time
y
y
manually.
It is recommended that you copy files to the TV memory before playing them, as playing directly from the USB
y
y
memory for an extended period of time may cause the device to overheat.
In EzSign 2.0 TV mode, some remote control keys may not work.
y
y
EzSign 2.0 TV dose not support the USB HUB. It is recommended that you connect a USB device directly to the TV
y
y
without using a USB extension cable as it may not work properly.
It is recommended that you use EzSign 2.0 TV within 8 hours per day as it is standard.
y
y
Refer to the EzSign 2.0 Editor user guide for details.
y
y
EzSign 2.0 TV does not support Store Demo.
y
y
Supported external subtitle format:*.smi/*.srt/*.sub(MicroDVD, Subviewer 1.0/2.0)/*.ass/*.ssa/*.txt(TMPlayer)/*.
y
y
psb(PowerDivX)
Do not update the EzSign content via wireless networking and a USB drive at the same time. And do not play content
y
y
from a USB drive while updating EzSign content via wireless networking.
TROUBLESHOOTING
General
Problem
Cannot control the TV with the remote
control.
No image display and no sound is
produced.
Image appears slowly when the TV
turns on.
Cannot connect external devices.
The TV turns off suddenly.
cAuTiON FOR uSiNG EzSign 2.0 / TROuBLESHOOTiNG
Check the remote control sensor on the product and try again.
y
y
Check if there is any obstacle between the product and the remote control.
y
y
Check if the batteries are still working and properly installed (
y
y
Check if the product is turned on.
y
y
y
y
Check if the power cord is connected to a wall outlet.
Check if there is a problem in the wall outlet by connecting other products.
y
y
The image is muted during the product startup process. This is normal. If the image does not
y
y
appear in a few minutes, unplug the TV for 30 seconds and try again. If the image still does
not appear, contact the authorized service center in your local area.
Refer to the Connection Overview and connect an external device.
y
y
Check the power control settings. The power supply may be interrupted.
y
y
Check if the Auto sleep feature is activated in the Time settings.
y
y
Refer to the Sleep Timer.
Solution
to
,
29
to
).
Advertisement
Chapters
Table of Contents
