Table of Contents
Advertisement
3
Network
3.1
Network and Internet
Home network
To enjoy the full capabilities of your Philips TV, your
TV must be connected to the Internet.
Connect the TV to a home network with a high-speed
Internet connection. You can connect your TV
wirelessly or wired to your network router.
Connect to network
Wireless connection
What you need
To connect the TV to the Internet wirelessly, you need
a Wi-Fi router with a connection to the Internet.
Use a high-speed (broadband) connection to the
Internet.
Make the connection
Wireless
To make a wireless connection...
1 - Make sure that the router of your wireless network
is switched on.
2 - Press , select Network and press
enter the menu.
3 - Select Connect to network and press OK.
4 - Select Wireless and press OK.
5 - Select Scan to scan for your wireless network. If
you have a router with WPS (Wi-Fi Protected Setup),
you can select WPS. Select your choice and press OK.
6 - In the list of found networks, select on your
wireless network. If your network is not in the list
because the network name is hidden (you switched
off the SSID broadcast of the router), select Manual
entry to enter the network name yourself.
7 - Depending on the type of router, enter your
encryption key - WEP, WPA or WPA2. If you entered
the encryption key for this network before, you can
select Done to make the connection immediately.
If your router supports WPS or WPS PIN, you
select WPS, WPS PIN or Standard. Select your
choice and press OK.
8 - A message will be shown when the connection is
successful.
WPS
If your router has WPS, you can directly connect to
the router without scanning for networks. If you have
devices in your wireless network that use the WEP
security encryption system, you cannot use WPS.
1 - Press , select Network and press
to enter the menu.
2 - Select Connect to network and press OK.
3 - Select WPS then press OK.
4 - Go to the router, press the WPS button and return
to the TV within 2 minutes.
5 - Select Connect to make the connection.
6 - A message will be shown when the connection is
successful.
WPS with PIN code
If your router has WPS with a PIN code, you can
directly connect to the router without scanning for
networks. If you have devices in your wireless
network that use the WEP security encryption system,
you cannot use WPS.
1 - Press , select Network and press
enter the menu.
2 - Select Connect to network and press OK.
3 - Select Wireless and press OK.
4 - Select WPS, then select WPS pin then
press OK.
5 - Write down the 8-digit PIN code shown on
screen and enter it in the router software on your PC.
Consult the router manual on where to enter the PIN
code in the router software.
6 - Select Connect to make the connection.
7 - A message will be shown when the connection is
(right) to
successful.
Problems
Wireless network not found or distorted
• Microwave ovens, DECT phones or other Wi-Fi
802.11b/g/n devices in your proximity might disturb
the wireless network.
• Make sure that the firewalls in your network allow
access to the TV's wireless connection.
• If the wireless network does not work properly in
7
(right)
(right) to
Advertisement
Table of Contents
