Led Indicator Of Wireless Receiver; Initial Setting An Id Of Wireless; Setting An Id Of Wireless - LG HB954TZW Manual

HB954TZW-AD_BCOLLLK_ENG_0799

LED indicator of Wireless Receiver

LED color
BLUE The Wireless Receiver is receiving the signal of
the Wireless transmitter.
RED The Wireless Receiver is in standby mode.
OFF (No display) The Wireless Receiver is turned off.

Initial Setting an ID of Wireless

1 Connect the Wireless Receiver and the rear
speaker (right, left) with the speaker
cables.:
2 Connect the power cord of the Wireless
Receiver to the outlet.:
3 Turn on the main unit and Wireless
Receiver:
The main unit and wireless receiver will be
automatically connected.
"z z " appears in display window
14
4/7/09 11:13 AM Page 14
Operation
ON Wireless
Receiver
-
-
POWER Switch

Setting an ID of Wireless

When the unit is manufactured, the ID is already set. If an interference
occurs or you use a new Wireless Receiver, an ID should be set again.
1 Turn on the main unit and Wireless
Receiver:
2 Press and hold STOP(x) on the front of
unit and MUTE on the remote control.
"REMATE" appears in display window.
3 Turn off the Wireless Receiver:
4 Turn on the Wireless Receiver:
A new ID is set.
Be careful of the following
If there is a strong electromagnetic wave product nearby, interference may
occur. Put the unit (Wireless Receiver and main unit) away from there.
(Ex: Microwave oven)
If there is no audio signal for longer than 10 minutes, the Wireless Receiver will
automatically switch to standby mode. In power saving mode, both LEDs will
turn red. LEDs will turn blue when there is any audio signal back.
If you operate main unit then wireless speakers (rear speakers) sound within a
few seconds in standby mode.
ON Wireless
Receiver
POWER Switch
-
POWER Switch
POWER Switch