Closing The Door; Installation - Zanussi ZFT11105XV User Manual

Table of Contents

Advertisement

Problem
Door is misaligned or interferes
with ventilation grill.
The temperature in the appli-
ance is too low/too high.
Door does not open easily.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.

CLOSING THE DOOR

1. Clean the door gaskets.

INSTALLATION

WARNING! Refer to Safety chapters.
POSITIONING
Install the appliance in a dry, well ventilated indoors
where the ambient temperature corresponds to the
Possible cause
The water drainage plug is not
correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrectly.
The appliance is not levelled.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened of-
ten.
There is no cold air circulation
in the appliance.
You attempted to re-open the
door immediately after closing.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
climate class indicated on the rating plate of the
appliance.
Solution
Position the water drainage
plug in the correct way.
Wrap the food products better.
Refer to "Operation" chapter.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
Wait a few seconds between
closing and re-opening of the
door.
9

Advertisement

Table of Contents
loading

Table of Contents