Internal Connectors - Asus ROG Strix Z390-I Gaming Manual

2. Memory LED (MEMOK_II_LED)
The MEMOK_II_LED will light up and remain lit while the MemOK! II function is in use.
When the re-training is complete, the MEMOK_II_LED will turn off.
ROG STRIX Z390-I GAMING MemOK II LED
1.1.9

Internal connectors

1. Intel Serial ATA 6Gb/s connectors (7-pin SATA6G_1~4)
®
These connectors connect to Serial ATA 6Gb/s hard disk drives via Serial ATA 6Gb/s
signal cables.
If you installed Serial ATA hard disk drives, you can create a RAID 0, 1, 5, and 10
configuration with the Intel
Z390 chipset.
ROG STRIX Z390-I GAMING
Intel SATA 6Gb/s connectors
®
•
•
1-10
ON
OFF
Rapid Storage Technology through the onboard Intel
®
ON
OFF
A
B
These connectors are set to [AHCI] by default. If you intend to create a Serial ATA
RAID set using these connectors, set the SATA Mode item in the BIOS to [Intel RST
Premium With Intel Optane System Acceleration (RAID)].
For more information on configuring your RAID sets, please refer to the RAID
Configuration Guide which you can find at https://www.asus.com/support.
MEMOK_II_LED
A B
SATA6G_1 SATA6G_3
GND GND
RSATA_TXP1 RSATA_TXP3
RSATA_TXN1 RSATA_TXN3
GND GND
RSATA_RXN1 RSATA_RXN3
RSATA_RXP1 RSATA_RXP3
GND GND
SATA6G_2 SATA6G_4
GND GND
RSATA_TXP2 RSATA_TXP4
RSATA_TXN2 RSATA_TXN4
GND GND
RSATA_RXN2 RSATA_RXN4
RSATA_RXP2 RSATA_RXP4
GND GND
Chapter 1: Product Introduction
®