Table of Contents
Advertisement
Listen to the radio
Tip
•
Position the antenna as far as possible from TV or other
radiation sources.
•
Make sure that you have connected the supplied FM
antenna.
•
For optimal reception, fully extend and adjust the
position of the antenna.
Tune to a radio station
1
Press FM/AUDIO IN repeatedly to select
the tuner source.
2
Press and hold
» The radio tunes to a station with
strong reception automatically.
3
Repeat step 2 to tune additional stations.
To fine tune a weak station:
•
Press
/
repeatedly until you find
optimal reception.
Store FM radio stations automatically
Note
•
You can store a maximum of 30 preset radio stations
(FM).
1
In tuner mode, press PROG for more
than two seconds to activate automatic
programming.
» [AUTO] is displayed.
» All available stations are programmed
in the order of waveband reception
strength.
» The first programmed radio station is
broadcast automatically.
2
press
/
to select a preset station.
Store FM radio stations manually
1
Tune to an FM radio station.
2
Press PROG to activate programming
mode.
» [PROG] (program) blinks.
12
EN
/
for 3 seconds.
3
Press ALBUM/PRESET
to select a radio frequency.
4
Press PROG again to confirm.
» The frequency of the preset station is
displayed.
5
Repeat the above steps to store more FM
stations.
Note
•
To remove a pre-stored station, store another station
in its place.
Select a preset radio station
•
In FM mode, press
radio station.
Show RDS information
RDS (Radio Data System) is a service
that allows FM stations to show additional
information.
1
Tune to an RDS station.
2
Press DISPLAY/RDS repeatedly to scroll
through the following information (if
available):
» Program service
» Program type such as [NEWS] (news),
[SPORT] (sport), [POP M] (pop
music)...
» Radio text message
» Time
Select stereo/mono broadcast
Note
•
Stereo broadcast is the default setting for tuner mode.
•
For stations with weak signals: to improve the reception,
change to monaural sound.
•
In FM tuner mode, press
between mono and stereo broadcast.
» [STEREO] (Stereo) is displayed when
the radio station is stereo broadcast.
/
repeatedly
/
to select a preset
to switch
Advertisement
Table of Contents
