Connecting The Tv With Stb (Sbb) - Samsung HG32EE590FKXXU Installation Manual

✎ The rear panel may differ depending on the model.
• Connect the DATA jack of the TV to the [ETH MODEM] jack of the STB (SBB) with the Data cable.
✎ Use data communication.
• IR signals sent by the remote control to the TV or SBB / STB must meet the following specification to use IR pass
through function.
IR signal receiver specification
‒ Band pass filter centre frequency: 37.9 ㎑
‒ Carrier Frequency, Duty 50%
‒ Minimum Burst Length (tburst): 12 pulses (316 us)
‒ Minimum Gap Time Between the burst (tburst gap): 16 pulses (422 us)
‒ Minimum Gap Time between the data commands (tpause): 25 ㎳
List of Vendors and Compatible Data Cables Supplied with the TV
¦
• Confirm that you are using the correct data cable for your vendor. Refer to the code label on the data cables.
1
STB SIDE
6
CON B
1: NC
2: GND
3: Rx
4: NC
5: Tx
6: IR
✎ Operation Specification of Data Cable(RJ12) : RS232

Connecting the TV with STB (SBB)

Data Cable
CON B CON B CON A
6 5
2 4
5 3
3 2
TV Rear Panel
6
TV SIDE
1
CON A
CON A
6: NC
5: IR
4: GND
3: Rx
2: Tx
1: Nc
English
15