Advertisement
Assembly
1
Attach Mount Assembly Brackets to Wall
1b. Mount on Solid Brick and Concrete Block
• When installing wall mounts onto a concrete masonry unit (also known as a CMU or "cinder block"), verify
that the actual concrete thickness is at least 35 mm (1-3/8") in order to hold the concrete anchors. DO
NOT DRILL INTO MORTAR JOINTS! Be sure to mount the assembled wall-mount plate with the included
concrete anchors, D6 washers and anchor bolts onto solid sections of the blocks. The solid sections can
generally be found 25 mm (1") toward the middle of the block from either end. An electric drill on a slow
setting is suggested to drill the hole rather than a hammer drill so as to avoid breaking out the back of the
hole when entering a hollow section.
• Installers must verify that the supporting surface will safely support the combined load of the equipment
and all attached hardware and components.
K
WARNING
5
60mm
60mm
(2.4")
(2.4")
10mm
10mm
( 3/8")
( 3/8")
Find and mark the
exact location of
mounting holes
W-B
Drill pilot holes
W-C
W-A
Screw the brackets
onto the wall
Advertisement
