Wireless Remote Controller (Optional) - LG LTUH286FLC0 Owner's Manual

Wireless Remote Controller (optional)

This air-conditioner is equipped with wired remote controller basically. But if you want to be
available with wireless remote controller, you pay for it.
Signal transmitter
(Transmits the signals to the signal receptor)
3
12
13
4
5
6
Heat Pump
14
Model
Cooling Model
The wireless remote controller do not operate the swirl mode.
• Aim at the signal receptor on the air conditioner so as to operate.
• The remote control signal can be received at a distance of up to about 7m.
• Be sure that there are no obstructions between the remote controller and the signal receptor.
• Do not drop or throw the remote controller.
• Do not place the remote controller in a location exposed to direct sunlight, or near the heating unit, or any
other heat source.
• Block a strong light over the signal receptor with a curtain or etc. so as to prevent the abnormal operation.
(ex:electronic quick start, ELBA, inverter type fluorescent lamp)
1
7
2
ON OFF
8
9
SET CANCEL
10
PLASMA
15
11
Flip-up door
(opened)
CAUTION
of handling the wireless remote controller
1 OPERATION DISPLAY
Displays the operation conditions.
2 ON/OFF BUTTON
Operation starts when this button is pressed and
stops when the button is pressed again.
3 JET COOL BUTTON
Used to select jet cool mode.
4 ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping
operation.
5 TIME SETTING BUTTONS
Used to adjust the time.
TIMER SET/CANCEL BUTTONS
6
Used to set the timer when the desired time is
obtained and to cancel the Timer operation.
7 AUTO SWING BUTTON
Used to swing up and down.
8 SLEEP MODE BUTTON
Used to set Sleep Mode operation.
9 AIR CIRCULATION BUTTON
Used to circulate the room air without cooling or
heating (turns indoor fan on/off).
10 ROOM TEMPERATURE CHECKING BUTTON
Used to check the room temperature.
11 RESET BUTTON
Used prior to resetting time or after replacing
batteries.
12 INDOOR FAN SPEED SELECTOR
Used to select fan speed in four steps-low, medium,
high, or auto.
13 ROOM TEMPERATURE SETTING BUTTONS
Used to select the room temperature.
14 OPERATION MODE SELECTION BUTTON
Used to select the operation mode.
15 PLASMA AIR CLEAN BUTTON(OPTIONAL)
6