Philips EP3559 User Manual page 24

Problem
The coffee is not hot
enough.
The machine does not
grind the coffee beans.
The machine grinds the
coffee beans, but coffee
does not come out or
coffee comes out slowly.
The milk does not froth.
Cause
The coffee exit duct is clogged.
The cups you use are cold.
The temperature is set too low.
Check the menu settings.
You added milk.
The coffee exit duct is clogged.
The coffee exit duct is blocked.
The AquaClean filter was not
prepared well for installation.
The grinder is set to a too fine
setting.
The brew group is dirty.
The coffee dispensing spout is
dirty.
The machine circuit is blocked
by limescale.
The milk carafe is dirty or not
inserted correctly.
The milk dispensing spout has
not been opened fully.
The milk carafe is incompletely
assembled.
Solution
Clean the coffee exit duct with the
handle of the measuring spoon or a
spoon handle. Then switch the
appliance off and on again.
Preheat the cups by rinsing them with
hot water.
Set the temperature to 'high' in the
menu.
Whether the milk you add is warm or
cold, it always decreases the
temperature of the coffee to some
extent.
Clean the coffee exit duct
Clean the coffee exit duct with the
handle of the measuring spoon or a
spoon handle. Switch the appliance off
and on again.
Switch off the machine and remove the
filter from the water tank. Immerse the
filter upside down in a jug with cold
water and wait until no more air bubbles
come out. Place back the filter in the
water tank, restart the machine and
dispense 2-3 cups of hot water.
Adjust the grinder to a coarser setting.
Clean the brew group.
Clean the coffee dispensing spout and
its holes with a pipe cleaner.
Descale the machine.
Clean the carafe and make sure that you
position and insert it correctly.
Make sure that the milk dispensing
spout is in the correct position.
Make sure that all the components
(especially the milk tube) have been
assembled correctly
English
25