Get Started; Connect; Prepare The Remote Control - Philips NTX400/79 User Manual

3 Get started

Caution
•
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
laser exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________

Connect

Connect FM antenna
Note
•
For better reception, fully extend and adjust the
position of the FM antenna.
Connect the supplied FM antenna to the FM
jack on the back of the main unit.
8 EN
Connect AM antenna
Note
•
For better reception, adjust the position of the AM
antenna.
1
Assemble the AM loop antenna.
2
Connect the AM loop antenna to the AM
jack on the back of the main unit.

Prepare the remote control

Note
•
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
•
Batteries contain chemical substances, so they should
be disposed of properly.
1
Open the battery compartment.
2
Insert one AAA battery with correct
polarity (+/-) as indicated.