Radio Reception; Tuning To Radio Stations; Programming Radio Stations; Automatic Programming - Philips MCM119 User Manual

Tuning to radio stations

1
Press SOURCE on the front panel of the
system or TUNER on the remote to select
TUNER.
➜ TUNER is displayed briefly.
2
Press TUNER on the remote once or more to
select your waveband (FM/ MW).
3
Press and hold à /á for 2 to 3 seconds.
➜
The radio automatically tunes to a station with
sufficient reception. Display indication during
automatic tuning: SEARCH.
4
Repeat step 3 if necessary until you find the
desired station.
●
To tune to a weak station, press à /á briefly
and repeatedly until you have found optimal
reception.

Programming radio stations

You can store up to a total of 40 radio stations in
the memory.

Radio Reception

Automatic programming

Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden.
1
Press í / ë to select the preset number
where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2
Press PROGRAM (PROG on the remote) for
more than 2 seconds to activate programming.
➜ AUTO is displayed and available stations are
programmed in order of waveband reception
strength: FM followed by MW. The last preset
automatically stored will then be played.

Manual programming

1
Tune to your desired station (see "Tuning to
radio stations").
2
Press PROGRAM (PROG on the remote) to
activate programming.
3
Press í / ë to allocate a number from 1 to
40 to this station.
4
Press PROGRAM (PROG on the remote)
again to confirm the setting.
➜
The preset number and the frequency of the
preset station are shown.
5
Repeat the above four steps to store other
stations.
●
You can override a preset station by storing
another frequency in its place.

Tuning to preset radio stations

●
Press í / ë until the desired preset station is
displayed.
17