Cobra microTALK LI 4900WX Owner's Manual page 14

Operation
Set DCS Privacy Codes
Mode Button
DCS Privacy Code
Channel Buttons
10
Mode Functions
To select a DCS privacy code:
1. After selecting a channel, press the Mode
button until the DCS icon appears and the
small numbers flash on the display
(01 through 83).
NOTE
If CTCSS is turned on at the channel
selected, the display will flash the
DCS icon and "OFF." To switch from
CTCSS to DCS, press the Channel Up
or Channel Down button while the
display is flashing "OFF." The display
will then show the small numbers
flashing and you will then be able
to proceed to step 2.
2. Press using the Channel Up or Channel Down
button to select a DCS privacy code. You can
hold the Up or Down button for fast advance.
3. When your desired DCS privacy code is
displayed, choose one of the following:
a. Press the Mode button to enter the new
setting and proceed to other functions.
b. Press the Lock/Enter button to enter the
new setting and return to Standby mode.
c. Do not press any buttons for 15 seconds
to enter the new setting and return to
Standby mode.
•