Maintenance Chart - DeWalt DXCMTB5590856 Instruction Manual

160cc, gas wheeled portable air compressor

Hide thumbs

Table Of Contents

Table of Contents

To prolong the air compressor's life, it is recommended to run at

high throttle 50-75% of the run time and idle for 25% of the run time

10. Attach hose and accessory.

WARNING: Risk of unsafe operation. Firmly grasp air hose in

hand when installing or disconnecting to prevent hose whip.

WARNING: Risk of unsafe operation. Do not use damaged or

worn accessories.

NOTICE: Risk of property damages. Compressed air from the unit

may contain wa ter condensation and oil mist. Do not spray un fil-

tered air at an item that could be damaged by moisture. Some air

op er ated tools or de vic es may require filtered air. Read the in struc-

tions for the air tool or device.

11. Adjust regulator (F) to desired setting. See Regulator under

Features.

Shut-down

1. Place the engine ON/OFF switch (C) to the OFF Position.

2. Place the fuel valve lever (O) in the OFF postion.

NOTE: If finished using compressor, follow Steps 3–7.

3. Turn regulator knob (F) counterclockwise until fully closed.

Ensure regulated pressure gauge reads 0 psi.

4. Remove hose and accessory.

5. Drain the air tank. See Draining Air Tank under Maintenance.

NOTICE: Risk of property damage. Place engine fuel valve lever

(O) in the OFF position before moving or transporting unit.

WARNING: Risk of bursting. Drain air tank daily. Water will

condense in air tank. If not drained, water will corrode and weaken

the air tank causing a risk of air tank rupture.

6. Allow the compressor to cool down.

7. Wipe air compressor clean and store in a safe, non freezing

area.

MAINTENANCE

WARNING:The following procedures must be followed when

maintenance or service is performed on the air compressor.

1. Ensure engine ON/OFF switch (C) is in the OFF position.

2. Disconnect spark plug wire.

3. Drain air tank.

4. Allow air compressor to cool down before starting service

NOTE: All compressed air systems contain maintenance parts (e.g.

oil, filters, separators) that are periodically replaced. These used

parts may contain substances that are regulated and must be

disposed of in accordance with local, state, and federal laws and

regulations.

NOTE: Take note of the positions and locations of parts during

disassembly to make reassembly easier.

NOTE: Any service operations not included in this section should

be performed by a D

WALT factory service center or a D

authorized service center.