Select Additional Programme; Settings; Start The Programme; Child Lock - Bosch WAW32668SN Instruction Manual And Installation Instructions

Table of Contents

Advertisement

Operating the appliance
en
Pressing and holding the buttons
Note:
automatically runs through the setting
values until the last one. Then press the
button again and you will be able to
change the setting values again.
The settings are activated without
needing to be confirmed.
Notes
The i-DOS settings are saved until
they are changed again, even if the
washing machine is switched off.
Other programme settings are not
saved if the washing machine is
switched off.
Default programme settings
~ Page 22

Select additional programme

settings

By selecting additional settings, you can
better adapt the washing process to
your items of laundry.
The settings can be selected or
deselected depending on the
programme progress.
The button indicator lamps light up if a
setting is activated.
The settings are not saved after
switching off the washing machine.
Additional programme settings
~ Page 23

Start the programme

Press the A button. The indicator lamp
lights up and the programme starts.
The display panel shows the "Ready in"
time while the programme is running or
the programme length and the
programme progress symbols when the
washing programme has started.
Display panel ~ Page 12
26
Note:
Foam detection
If the Å symbol also lights up in the
display panel, the washing machine has
detected too much foam during the
wash programme and automatically
activated additional rinse cycles to
remove the foam.
Add less detergent to the next washing
cycle with the same load.
If you want to lock the programme to
prevent it from being inadvertently
adjusted, you can select the childproof
lock as follows.

Child lock

(E 3 sec.)
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently. To do this,
activate the childproof lock.
To activate/deactivate, press and hold
the Ready in - and + buttons at the
same time for approx. three seconds.
The E symbol is appears in the display
panel.
E lights up: The childproof lock is
active.
E flashes briefly: The childproof lock
is active and the programme
selector was turned or a button was
pressed.
The childproof lock remains
Note:
active, even once the washing machine
has been switched off. Before selecting
the next programme, deactivate the
childproof lock.

Advertisement

Table of Contents
loading

Table of Contents