Advertisement
Quick Links
Advertisement
Related Manuals for Saga Gain SAGA1-L12
Summary of Contents for Saga Gain SAGA1-L12
- Page 1 SAGA1-L12 Industrial Remote Controller Operating Manual ® Gain Electronic Co., Ltd.
-
Page 2: Warranty
FCC Caution: "Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment." Warranty Gain Electronic Co., Ltd. guarantees that this product meets its published specifications at the time of shipment from the factory. - Page 3 SAGA1-L12 Operation SAGA1-L12 Standard Accessories When you get a standard and full set of SAGA1-L12 system, it includes the following item.: (1)Transmitter, one unit. (2)Receiver, one unit. Remarks： (1). Hamming Distance-------------≧4 (2). I.D. Code--------------------------More than 42 billion ID Code(32bit) (3). Channel Spacing----------------267.5KHz...
- Page 4 SAGA1-L12 Transmitter’s parts Antenna EMS Mushroom LED Indicator Motion Pushbutton Start Pushbutton Remarks： (1). Power----------------------Two 1.5Volt Alkaline Batteries（AA Size） (2). Dimensions----------------274×77×42mm (3). Weight---------------------about 540g（W/batteries）...
- Page 5 SAGA1-L12 Receiver’s parts Circuit Diagram Cable Remarks： (1). Input Voltage------------------------------110VAC（50/60Hz）±10% (2). Output Relays-----------------------------10A/250VAC. (3). Dimensions---------------------------------253×267×150mm（L×W×H） (4). Weight--------------------------------------about 3000g（W/O wire cable）...
- Page 6 How to use Insert 2 AA-size alkaline batteries into battery compartment. Insert magnetic key or rotary key and switch to ON position. Follow the Power-On procedure to energize the main relay inside receiver. Operate normally according to the function settings have been done. After operation, please proceed as following: (1) Press EMS pushbutton /mushroom, (2) remove the key and keep it in safe place, (3) Switch off the equipment’s main power (e.g.
- Page 7 (3) Press DOWN pushbutton 4 times and release “STOP & UP” pushbuttons when red LED flash. (4) Start the system as usual. Note: (1) By follow the procedures above, all the radios of same model within its radio operating distance, might be affecting by ID code remote setting.