Table of Contents
Advertisement
Positioning and connecting
en
Running the programme without
laundry:
Switch on the appliance.
1.
Close the door (do not load any
2.
laundry).
Set the Drum Clean 90 °C
3.
programme.
Open the detergent drawer.
4.
Pour approximately 1 litre of water
5.
into compartment II.
Pour standard washing powder into
6.
compartment II.
To prevent foaming, only use
Note:
half the amount of detergent
recommended by the detergent
manufacturer.Do not use detergents
intended for woollens or delicates.
Close the detergent drawer.
7.
Press the A button.
8.
Switch off the appliance at the end of
9.
the programme.
Your washing machine is now ready to
use.
Transportation
e.g. when moving home
Preparatory work:
Turn off the water tap.
1.
Reduce the water pressure in the
2.
supply hose.
Maintenance – filter in the water
supply ~ Page 39
Drain the remaining detergent
3.
solution.
Maintenance – detergent solution
pump blocked
Disconnect the washing machine
4.
from the mains.
Remove the hoses.
5.
Installing the transport locks:
Remove the covers and keep them
1.
in a safe place.
Use a screwdriver if necessary.
18
Insert all four sleeves.
2.
Clip the mains cable securely in the
holders. Insert and tighten the
screws.
Before switching on the appliance
again:
Notes
The transport braces must be
■
removed.
To prevent unused detergent from
■
flowing straight into the drain during
the next wash: Pour approx. 1 litre of
water into compartment II and start
the Drain program.
Advertisement
Table of Contents
