Philips HF3500/60 Manual page 9

2 To select the desired radio frequency, press the « and » buttons.
Tip: To scan radio frequencies automatically, press and hold the « or » button
for approx. 2 seconds.
Tip: To make sure you get a good radio signal, fully unwind the antenna and
move it around until you have found a position at which reception is best.
Note: The current radio frequency is shown in the display for 5 seconds, before
clock time is shown again.
3 To switch off the radio, press the radio on/off button again.
Volume
1 To set the volume, press the volume increase or decrease button.
You can choose a volume level between 1 and 10.
Note: The volume level you have selected is automatically set as the volume
level for the alarm as well.
Adjusting the display brightness
1 Press the display brightness button to adjust the display brightness.
HF3505: You can change the brightness of the display from high, medium,
low to off. If you choose the display to be off, you can see the display again
by touching it.
HF3500: You can change the brightness of the display from high, medium,
low to very low.
Note: We advise you to set the display brightness in a dark bedroom. Choose a
brightness level that is optimal for you to see the display at night.
Demo mode
If you want a quick demonstration (90 seconds) of the gradually increasing
light intensity and sound level, switch on the test function of the appliance.
1 Press and hold the alarm button for at least 3 seconds.
2 The appliance starts the demonstration of the alarm.
3 To switch off the demonstration, press and hold the previously
pressed alarm button for 3 seconds again.
ENGLISH
9