Table of Contents
Advertisement
4. Abnormal screen
Check the R, G, B video signal from computer input on
D-Sub R, G, B connector.
OK
Check the R, G, B input signals on I301 pin 12, 20, 28,
respectively that their level is 0.7Vp-p maximum.
OK
Is the pulse of the TTL level being output to P303, P304
from the data line of I300?
OK
Check the negative horizontal sync pulse output to P304
pin 38 from I300 pin 80 at TTL level.
OK
Check the negative vertical sync pulse output to P304 pin
40 from I300 pin 75 at TTL level.
OK
Check the positive DE pulse output to P304 pin 42 from
I300 pin 74 at TTL level.
OK
Check the SHFCLK OUTPUT to P304 pin 44 from I300
pin 44 at TTL level.
OK
Process "Checking the resolution change IC movement"
Page 6
NG
1) No R, G and B video signal output from host computer. Check
2) Video signal cable disconnection.
In case of the Red signal. (A Green and Blue signal is the same
NG
path, too.)
1) Printed wire broke between D-Sub(R) and I301 pin 12.
2) R341 short.
3) C321 open.
4) R362 open.
NG
1) Printed wire broke between I300 data line and P303, P304
2) I317 failure.
NG
1) Printed wire broke between I300 pin 80 and P304 pin 38.
2) R351 open
NG
1) Printed wire broke between I300 pin 75 and P304 pin 40.
2) R352 open
3) C416 short
NG
1) Printed wire broke between I300 pin 74 and P304 pin 42.
2) R355 open
3) C382 short
1) Printed wire broke between I306 pin 44 and P307 pin 44.
NG
2) FB314 open
3) FB315 open
4) C380 short
5) C381 short
section.
Failure point
computer
Failure point
Failure point
Failure point
Failure point
Failure point
Failure point
A L C502
Trou bl e Sh ooti ng
Advertisement
Table of Contents
